Your shower could be a very frightening area each time those soap suds begin to accumulate around the bottom of your shower. One way to really feel less hazardous at the shower is to choose a grab bar at the wall. Here i will discuss the appliances you need and then recommendations to effectively install a grab bar in the tiled bathroom shower.
- Philips-head screwdriver
- Drill
- 1/8 inch masonry bit or glass and tile bit
- Stud finder or a length of wire
- Tape measure
- Silicone caulk
- Sharp awl or carbide glass and tile drill bit
- Wood bit, 1/16 narrower than the size of mounting screws
The first thing that you’ve got to implement to build the grab bar is to discover a wall stud. If you have had service to a stud finder this will assist you so much. Get the stud finder over the wall until a wall stud is found and make sure to draw the position with a fine point marker. If you do not own a good electronic stud finder, don’t worry, just grab a 1/8 masonry bit or glass along with tile bit and then simply drill a hole into the grout. After that bring your length of wire and create a fold inside. Position the wire inside the hole and by simply spinning it left and right you will definitely reach a stud. If you do not see a stud, the hole that you just drilled should be filled with a small bit of silicone caulk. Don’t forget to flatten the dab of silicone caulk so it does not protrude from the grout path, make the caulk to dry for around three hours. For those who have powdered grout handy, mix up a little bit then patch the hole. Re-drill another hole until finally you locate a stud. When you do discover a stud, determine 16 inches from that hole and you are able to drill towards a second stud.
It is advisable to tag your stud locations so that you could measure from the base of the tub to find out the place of your current bar. Put your bar to let each end should be over a stud and mark the screw holes which are in the mounting bracket.
To help you drill the mounting holes into tile you’ve got to get a beginning spot for that drill bit or else the bit will go throughout the tile. To generate a starting point apply a sharp awl or afore described drill bit. Using your hand, twist the instrument on your make to create a moderate effect around the tile; this may prevent your drill bit from slipping. Do not ever utilize a punch otherwise you are likely to break your tile. Use the glass and tile bit to drill the hole. If choosing a masonry bit, place tape within the tile and after that drill gradually to prevent shattering the tile. You actually never want to crack the tiles while screwing the mounting brackets on either so utilize a bit that’s 1/32 wider than the measurement of the mounting screw you are choosing. Start drilling the hole gently and with even pressure so as not to slide off your mark. Use soft pressure while drilling to avoid cracking the tile.
Be sure not to drill deeper than the tile and it backing. At this stage, you must switch your bit into wood bit 1/16 less wide than the screw. This would make a pilot hole in the studs.
A final step is to install the bar. Silicone caulk will surely have to be applied to the holes before installation; this process is to defend the wood and backing boards behind the tiles from leaking water. Simply screw the bar on the wall. You will need to use stainless steel screw otherwise they will corrode. Fasten the screws tightly keeping to not over tighten them or they will crack the tile.
You may then get your grab bar nicely installed. Now you may take a peaceful, comfortable shower and feel safer in the way.
Related posts:
